Dimensions
6 HP
22 mm deep
Current Draw
35 mA +12V
30 mA -12V
? mA 5V
Price
$100 Price in €

Available as an assembled Module and as a DIY project.

This Module is a prototype or in a concept phase.

3phaseVCO 6hp

The core of this module is three distorted sine-ish waveforms 120° apart.
These outputs are labelled A, B, and C.
A, B, and C are summed together with overdrive to make the MIX output.
The MIX knob and CV applied to the MIXCV jack modulate the level of A in this mix, morphing between two flavours of rounded square wave at each end, with a sweet spot near the middle that mimics 3X the main frequency (octave + perfect fifth).
The MIXCV knob attenuates whatever is plugged into the MIXCV jack.

FREQ and FINE adjust the frequency between 0.08Hz (~12 seconds per cycle) and ~1.7kHz. Adjust C1, C2, and C3 to modify this range.
A notable drawback feature of this simple design is that the amplitude of A, B, and C is proportional to frequency. Expect approx. 5Vpk-pk at the lowest frequency and 12Vpk-pk at the top end of the range.

LIN - linear frequency modulation input (with attenuator)
EXP - 1V/octave control voltage input.
1V/octave tracking is calibrated with the trimmer accessible from the front panel between the FREQ and FINE knobs, expect at least 2 octaves of good tracking in the middle of the range.

instagram.com/isaacbeersbeers/


submitted Apr 17th 2023, 12:04 by Zipnil | last Change Apr 26th, 05:50 by isaacbeers
Affiliate Disclosure
This page contains affiliate links from eBay, Reverb.com and other partners for which ModularGrid may be compensated.