Midi-DAC

Monophonic Midi to CV interface

The Oakley MU MidiDAC has been designed to work with all 1V/Oct inputs It has two convenient Mults which can be normalised to the Pitch and Gate outs.
featured on the circuit board itself is a 3-way header to directly feed the Oakley CV and Gate to the buss on the Oakley Dizzy board.
The Unit has a midi In and Thru
Outputs.
Pitch: voltage conforming to 1V/octave (trimmable). Pitch bend is added to this signal and can be trimmed to give the maximum bend interval. It can be trimmed to zero if required.
Velocity: 0 to 10V proportional to midi note on velocity.
Pitch Bend: This signal is available individually. It is bipolar; so with no bend, the output CV is zero.
Modulation wheel: 0 to 10V proportional to mod wheel position.
Gate: +5V
CC: Continuous controlled number 100.
Aftertouch: 0 to 10V proportional to midi channel aftertouch.
Legato: This signal goes to +5V when two notes are played at the same time. This can allow slides to be switched in at will; TB303 style.
Power Requirements
Synthesizers.com header. Current consumption is approximately +40mA and -30mA.
Case depth 115mm or 4.50inch.

http://www.krisp1.com/store/index.php?main_page=product_info&cPath=8&products_id=117