Midi to CV interface from AtomoSynth

CV1 PITCH output 0 to +5 Volt range (5 octaves) it comes from a very accurate 12 bit resolution (4096 steps) digital to analog converter DAC, which translates the incoming midi note messages to voltage. It also responds to the pitch bend or pitch wheel control, according to the midi standard it has a range of +/- two half steps.

Glide effect, it affects the CV1 PITCH output.

Gate output 0 or +5 Volt. it has a red LED that indicates when there is an active gate signal.

CV2 output 0 to +5 Volt range, it comes from a 7 bit resolution (128 steps) digital to analog converter, it can be easily set to output the velocity or any controller CC from the midi device.

PROGRAM button allows you easily set the midi channel just by pushing it and then pushing a note in your midi keyboard, the midi channel will be automatically set and stored even when the unit is turn off. It also allows you to set the controller CC for the CV2 output, just push the Program button and move any controller in your midi device and it will be set automatically.

Midi In and Midi Thru connectors, allows you to connect many midi devices in chain.

http://www.atomosynth.com/koneko.html

  • ? mA +12V
  • ? mA -12V
  • ? mA 5V

No info about availability.

$119
14 HP MIDI
submitted Dec 29th 2012, 23:59 by spitznagl | last Change Jan 1st 2013, 16:06 by solitud

Buy Online

These merchants probably sell this module. Huh?

USA

Perfect Circuit