Spring Reverb

CV controlled Spring Reverb

Block Diagram

  • Two audio inputs. Both CVcontrolled and with slider control.
    “IN1″ is routed both to “DRY” mix and reverb tank input.
    “IN2″ Goes only to the reverb tank.

  • Two outputs
    “WET” comes stright from reverb tank.
    “MIX” is the mix of DRY signal and the outpur of reverb tank. It has CV control

  • High pass filter at the input of the tank to control the tone of the reverberations and an eventual saturation of the spring when we are doing a feedback.

  • Built-in vumeter at “WET” output to visualize level and eventual saturation of the signal.

  • Optimized for 8BB2A1B Tanks

http://www.befaco.org/en/spring-reverb/

  • 51 mA +12V
  • 34 mA -12V
  • 0 mA 5V
  • 47 mm deep
  • Ø 4.00 (1 Votes) Average Rating

Available as an assembled Module and as a DIY project.

No info about availability.

$246 Price in €
8 HP Effect
submitted Oct 14th 2014, 10:59 by Befacosynth | last Change Mar 7th 2015, 17:41 by Befacosynth
Specs are approved by the manufacturer

3 Users are observing this