ED702 - Synth-A-Scope

Oscilloscope

The ED702 is a single-channel oscilloscope ideal for monitoring signals in your system.
Parameter Value
Real-time sampling rate 1MSPS (max)
Sensitivity 1V/div - 5V/div in "1-2-5" steps
Timebase 10uS/div - 500uS/div in "1-2-5" steps
Capture buffer size 1024 bytes
Trigger modes Automatic/Normal/Single
Display size 2.4" (61mm)
Display resolution 320 pixels x 240 pixels
Input impedance 1M ohm/20pF
ADC resolution 12-bits

The DataLogger section at the top of the screen displays:-

Vpp - Shows the difference between the exteme Maximum and Minimum values
Vavr - The Average reading is the mean vertical level of the entrie captured waveform
Freq - The Frequency is the inverse of the Period and is measured in Hertz

Pressing the [SELECT] button steps the user through the various control settings displayed around the edge of the screen, the currently active setting being highlighted within a blue frame. AT each setting, pressing the [-] and [+] buttons will step through the available options.

Pressing the [HOLD/OK] button will freeze the current display allowing for closer inspection of the input signal.

Pressing the [HOLD/OK] button while in the lower left corner of the screen, the user can toggle the [AUTO SIZE] ([A.S]) function on and off. When enabled, [A.S] will automatically resize the input signal to fill the scope display area. This is useful when you have a signal on the display which doesn't optimally fit in any of the [VOLTS/DIV] settings. The DataLogger still displays the correct data for the input signal.

www.elby-designs.com/webtek/panther/ed702-synth-a-scope/ed702.htm

  • 90 mA +12V
  • 10 mA -12V
  • 0 mA 5V
  • 60 mm deep
  • Ø 1.00 (1 Votes) Average Rating

Available as an assembled Module and as a DIY project.

This Module is currently available.

$177 Price in €
15 HP Utility
submitted Oct 30th 2016, 20:58 by WidgetOz | last Change Feb 14th 2018, 01:37 by Lugia

8 Users are observing this