RYO Optodist (Grayscale panel)

Voltage controlled vactrol distortion/overdrive with LED limiter

Grayscale panel for the RYO Optodist by Ljunggren Audio:
http://grayscale.info/panels/roll-your-own-ryo-optodist/

See http://www.muffwiggler.com/forum/viewtopic.php?t=98339 for info.

Available as pcb, front panel, kit and assembled module.

A compact, easy to use, easy to build and great sounding distortion module which will also work as a VCA if desired.

The Optodist is based on two Silonex optocouplers that gives its characterful overdriven sound and plucky dynamic response to CV, it is equally at home adding a bit of extra crisp to highs and mids or warming up your lows as it is turning a resonant filter into a howling beast or your drums into crushing carnage. We offer two choices of optocouplers, SR2 and SR3, the latter giving a tighter, snappier CV response and slightly less bleed. Please note that due to the nature of the vactrol-style optocouplers, response behaviour may vary between different factory batches.

Also on board is an LED based limiter circuit which limits the signal thru a set of 4 LEDs which can be seen on the panel, for adding a different flavour to your distortion, the choice of LEDs is up to you, experimenting with different types will affect the sound.

The Optodist is a novice-friendly project, it is a low part count, single-PCB build that only requires the most basic experience in PCB soldering and module assembly. Kits comes supplied with PCB, front panel (PCB material), component kit, knobs, power cable and mounting screws. Solder and tools are not supplied.

http://ljunggrenaudio.com

  • 16 mA +12V
  • 16 mA -12V
  • ? mA 5V
  • 31 mm deep
  • Ø 4.75 (4 Votes) Average Rating

Available as an assembled Module and as a DIY project.

No info about availability.

$100 Price in € submitted Nov 27th 2013, 00:42 by sempervirent | last Change Jun 9th, 01:59 by sempervirent
Specs are approved by the manufacturer

3 Users are observing this