M-330 Clock To MIDI Sync


M-330 Clock to MIDI synchronizer. Allows sync MIDI devices from Eurorack clock.

Clock in jack (24 clock ticks means 1 quarter note in slaved MIDI device)
Start, Continue and Stop input jacks
Divided clock output jack for driving eurorack modules + button + LED.

There are two main modes of operation (selectable by long button press):
in first mode are clocks sent to MIDI independently of current „running state“ (MIDI clocks and divided clock out are active everytime). Starting slaved MIDI devices requires start (or cont) trig.
in second mode are clocks sent to MIDI only if current „running state“ is running (MIDI clocks and divided clock out are active only after „Start“ or „Continue“ – system is running, MIDI clocks and divided clocks are not sent after „Stop“ – stopped system)

Divided clock output can be set to „without triplets“ or „with triplets“ mode (selectable by holding button at power-up):
without triplets contains 1/4 note, 1/8 note, 1/16 note, 1/32 note or as raw clock input (nondivided)
with triplets contains 1/4 note, 1/8 note, 1/8 triplets, 1/16 note, 1/16 triplets, 1/32 note, 1/32 triplets or as raw clock input (nondivided)

Current clock division ratio is selectable by short button press cyclically (with or without triplets).

Width: 6TE/ 6HP/ 30mm.
Depth: 45mm /1,8″ max.
Current: 20mA max. from +12V only (no need for 5V rail)
Power cable included.

Double check power connection before powering your system please.
„Red strip“ means -12V connector side in Eurorack standards.
In some power distribution systems connector key can be reverted.
In this case cut connector key and plug power connector right way (with respect to red strip) or use different power cable appropriate to your power system.


  • 20 mA +12V
  • ? mA -12V
  • ? mA 5V
  • 45 mm deep
  • Ø 3.00 (1 Votes) Average Rating

No info about availability.

$91 submitted Jan 27th 2015, 22:54 by 11ish | last Change Dec 4th 2015, 15:04 by ParanormalPatroler