Time Buffer

STG Soundlabs Offer Details



Not in original box.The time buffer is a clock conditioner and distribution
amplifier for injecting and distributing sync24 (also known as "din
sync") into and throughout a modular synthesiser for any stg soundlabs
clock bus compliant modules such as the graphic sequencer and the
trigger sequencer. there are connections on the circuit board of this
module to send clock to up to 7 devices, or eight if the front panel
output is disconnected. Connections:
sync24 input - this accepts a 5 pin din cable, and expects to see a 24
ppq din sync signal. the two outer pins and centre pin must be wired for
the cable to work. Sync24 output - this is a conditioned
courtesy outlet for the clock signal. this is provided because many din
sync devices are silly and only provide either an input or output or
shared input/output connection. Power:
this module, along with the graphic sequencer and the trigger sequencer,
uses only the five volt power rail of your system. if you do not have
five volt power already in your system, a regulator board can be
purchased which is strong enough to power 5 time buffer.

STG Soundlabs Time Buffer

This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.

Look up on

Disclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.

If you think an offer sounds suspicious please report to info@modulargrid.net