PS3100 Triple Vactrol Resonators

Fonitronik Offer Details


Korg PS3100 Triple Vacrol Bandpass Resonators clone with LFO

  • 114 mA +12V
  • 20 mA -12V
  • 30 mm Depth
20 HP FilterLFO
Go to the Module Detail Page


This is a DIY build of a Fonitronik PS3100 Triple Vactrol Resonators, based on the back end of the Korg PS3100 polysynth. This module consists of three bandpass filters plus an internal LFO to animate them. Each filter can be used on its own or all three can be used to process a signal in parallel and then output a mix of the resulting filtered signals. There is one quirk with the operation of this module: the bottom channel is overly sensitive to the internal LFO and so requires much smaller amounts of the CV knob compared to the other two channels. Otherwise, it's in good working condition and I stand behind it as an experienced DIY builder.Includes power cable. 

Fonitronik PS3100 Triple Vactrol Resonators

This offer was fetched from You cannot contact the seller via ModularGrid. You have to visit their site.

Look up on

Disclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.

Don't pay via PayPal Friends and Family if the seller is not your friend or family!

If you think an offer sounds suspicious please report to