281 Dual Function Generator (Barcode panel)

Toppobrillo Offer Details


DIY clone of half a Buchla 281. Toppobrillo PCB, Barcode panel/control PCB

Go to the Module Detail Page


This is a DIY build of a Toppobrillo 281 Dual Function Generator in good working condition. This is a clone of half of the original Buchla 281 module and consists of two looping AD/AR envelope generators with trigger outputs for the end of cycle. There's also a quadrature mode with an output for a mix of both envelopes. This was built using the Barcode-designed panel and control PCB in blue, with blue fresnel LEDs. I'm an experienced builder and I stand by this build. Includes power cable.

Toppobrillo 281 Dual  Function Generator

This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.

Look up on

Disclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.

Don't pay via PayPal Friends and Family if the seller is not your friend or family!

If you think an offer sounds suspicious please report to info@modulargrid.net