qMI2 - Quad MIDI Interface

Vermona Offer Details


Quad Polyphonic MIDI to CV/Gate Interface


  • 60 mA +12V
  • 2 mA -12V
  • 30 mm Depth
Go to the Module Detail Page


USED in FUNCTIONAL CONDITION. See Photos for Cosmetic Condition.the qmi - quad midi interface is now replaced by the qmi 2 which got some small improvements:

there is a new gate input which allows switching between monophonic playmodes m1 and m2 using a gate signal.
the qmi 2 now has three clock outputs (instead of four on the former
version). each clock out can be set up individual for sending ¼, ⅛, 1⁄16 and ⅛t triggers
generated out of the incoming midi clock.

each channel button can generate either a trigger signal with fixed length (10ms) or a gate signal.

vermona's second eurorack module is a very flexible yet affordable
midi/cv interface which can be up to four voice polyphonic. you can use
it as four independent interfaces or in a mixed mode with
simultaneous monophonic and polyphonic modes.

each of the "output channels" has a cv output with 1v/octave, a gate
output and two further control voltage outputs for midi controllers like
modulation wheel and pitch bend wheel. the output channels can be
combined arbitrarily with each other or used totally independent with
different midi channels. combined output channels can be unison,
monophonic with rotating voice assignation or polyphonic.

there are four clock divider outputs that convert incoming midi clock
signals as analog gate voltages. a reset output allows e.g for keeping
step sequencers (with an according reset input) by midi start/stop
commands in sync.

an important part of the concept is the simple use of all parameters without a display and complicated menu structures.

pitch-cv: 1v/octave
gate voltages: 10v
cv1, cv2: 0-5v (or -2,5v..+2,5v with pitch bend)
legato function switchable per output channel
clock outputs (10v): 1/4, 1/8, 1/16 and 1/8t (can be doubled)
reset output: 10v at midi stop, 0v at midi start or continue

inputs and outputs:
midi input
outputs per channel 1-4: gate, 1v/okt, cv1, cv1
clock depending outputs: reset, ¼ ⅛, 1⁄16, ⅛t

measurements and weight:
3u eurorack module
24 hp wide
30 mm deep
current draw 60ma

Vermona QMI 2

This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.

Look up on

Disclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.

If you think an offer sounds suspicious please report to info@modulargrid.net