CV Processor / Polarizer

CGS114

Based on the Ken Stone CGS114 schematic. This is essentially a DIY clone of the CGS114 Voltage Processor. Functionality is also commonly referred to as a polarizer.

A 3 channel mixer, that allows to add or to subtract 3 incoming voltages to the output signal. In the middle position of the corresponding control the amplification is zero. Turning the knob counterclockwise the signal is subtracted from the output sum with increasing amount. Turning the knob clockwise the signal is added to the output sum with increasing amount. The output control works in the same way, i.e. the resulting output signal can be additionally attenuated and/or inverted.

The module can be used to mix control voltages (e.g. ADSR, LFO). It can be used to mix audio signals too but there is no difference between adding and subtracting audio signals unless they have a fixed phase relationship (e.g. the outputs of a VCO, or the input and output signal of a VCF). For audio signals without phase correlation there is no difference between addition and subtraction.

https://www.coroflot.com/briantuley

  • ? mA +12V
  • ? mA -12V
  • ? mA 5V
  • 35 mm deep
  • Ø 3.00 (1 Votes) Average Rating

Module is available as a DIY project only.

This Module is a prototype or in a concept phase.

submitted Jan 20th, 05:38 by Ambriant | last Change Jan 25th, 21:13 by Lugia