Dimensions
8 HP
38 mm deep
Current Draw
20 mA +12V
18 mA -12V
0 mA 5V
Price

Module is available as a DIY project only.

This Module is currently available.

LFO, Slew limiter and Envelope generator by KYMATICA DEVICES

One module, three functions.

The LFO is a typical standard LFO with saw-tri-ramp shape, as well as a pulse/square output.

The slew limiter allows linear or typical RC-curve slew limiting.

The envelope generator has two attack modes: Gated, where the attack phase is cancelled if gate goes low, and Triggered, where attack phase always finishes until it reaches the target peak voltage. The sustain knob controls the S level. At 0% it gives an AD envelope, at 100% an ASR. The shape knob controls the balance between A and D/R. So D and R has the same time, just like on the minimoog.
In Triggered attack mode, the attack phase always finishes even if the trigger/gate is shorter, this makes it possible to use as a clock divider or "subharmonic generator".

So the shape knob affects the waveform shape for all three functions.
Same with the rate knob and range switch.
The lin/log switch affects both the slew limiter and envelope generator. (it needs to be in LIN position for the LFO).

The RISE/FALL outputs put out a high gate when the output is rising or falling, and works for all three functions.

www.kymatica.com/hardware


submitted Sep 15th 2019, 14:28 by kymatica | last Change Sep 16th 2019, 14:22 by kymatica

1 Users are observing this