A eurorack module for the distribution of CV signals. In essence linked buffered multiples.

The Coriolis Instruments Multibus is a eurorack module for the distribution of CV signals. In essence it is 9 1-to-3 buffered multipes with signal indicators in grouped in three channels of three multiples. The "twist" is that every single multiple can be switch to work solo, so when you are not using the multiples as a distribution bus, you can still use them for something else.

You can use multiple inputs to combine signals (triggers, lfo's) like you would with a mixer and distribute these signals around your case. The Multibus has a variable gain for each channel, with the gain ranging from 0 to 1 (unity gain). This way you are free to combine triggers using unity gain or audio or lfo signals with a lower gain setting to prevent clipping.

Or intentionally clip your mixed audio of course ;)

1. This module has Surface Mounted Devices (on the main_board pcb). They are of average SMD size (SOIC-14, 0805), but still very small. Make sure you have the appropriate tools to work with these (like tweezers and such).
2. The current ratings are estimates, they have not been measured (yet).

  • 100 mA +12V
  • 100 mA -12V
  • 0 mA 5V
  • 30 mm deep

Module is available as a DIY project only.

This Module is a prototype or in a concept phase.

Module is a 1U tile.

submitted Jan 5th, 20:55 by krispy | last Change Tuesday February 12, 14:02 by krispy