Dimensions
4 HP
25 mm deep
Current Draw
16 mA +12V
13 mA -12V
0 mA 5V
Price

Module is available as a DIY project only.

This Module is currently available.

Voltage Controlled Aux Send with EQ

Feed V2 is a VCA with with an integrated EQ. It is being designed as some kind of voltage controlled aux send module. The new version V2 has an improved Tone response and its horizontal pitch has been reduced from 8HP to 4HP.

If you insert an audio source into the jacks IN it will be directly routed to the THRU jack where you may use you original signal for further processing.

The signal is also directly routed to the VCA. Here you can control the volume or amplitude of the audio either manually or via control voltage using the CV jack.

Additionally you may change the frequencies of the signal using the TONE potentiometer. Turning counterclockwise will add low and cut high frequencies und turning the knob clockwise will cut low and boost high frequencies.

This works well with drums that will be send to an delay, reverb or any other effect when control voltage is being send to the CV jack.

Details:

● Voltag Controlled Amplifier
● Volume Control
● CV Attenuator
● Built in EQ
● Original signal is routed to THRU out
● Wrong polarity protection
● Skiff friendly
● 3U Eurorack module, 4 HP wide
● Power consumption: 30 mA at +12 V and 12 mA at -12 V

The module consists of two boards:

● Front PCB Panel
● Main PCB with all components

http://www.st-modular.com


submitted Feb 14th 2018, 19:34 by Stobbert | last Change Jan 15th 2019, 13:24 by modulargrid

7 Users are observing this

Affiliate Disclosure
This page contains affiliate links from eBay, Reverb.com and other partners for which ModularGrid may be compensated.