1 U
112 mm deep
Current Draw
50 mA +15V
14 mA -15V
0 mA 5V
$69 Price in €

Module is available as a DIY project only.

This Module is currently available.

TLN-904 Veeblefetzer

Signal Level Meter

The TLN-904 Veeblefetzer is a signal level meter for modular synthesizers. This module produces no sound; it is used to indicate signal level (voltage level) for both audio and control signals. I built this module because I got tired of hauling the scope over to my synth every time I wanted to check the level of a signal, or to figure out if a signal was bipolar or unipolar. It also provides lots of blinkenlights to mesmerize anyone who comes within visual range of your synth.
The Veeblefetzer features:
A 10 segment LED display driver for positive voltages (typically set for half volt increments from 0.5V to 5.0V).
A 10 segment LED display driver for negative voltages (typically set for half volt increments from -0.5V to -5.0V).
A zero LED driver for voltages that are too small to register on either the positive or negative displays.
An adjustable positive peak detector LED driver.
An adjustable negative peak detector LED driver.
Two jacks on the front panel make it easy to hook the Veeblefetzer into a patch without having to use a multiple.
Description of panel controls:
The MODE switch selects either BAR or DOT mode on the two 10 segment LED display drivers.
The RANGE switch selects either a FIXED range for the two 10 segment LED display drivers (typically -5V to +5V) or an adjustable range that follows the PEAK knob setting. The adjustable range mode would be used to zoom the display out for viewing 20Vpp signals or to zoom the display in for viewing 1Vpp signals.
The PEAK pot sets the level of the positive and negative peak detectors: 0V to +10V for the positive peak detector, 0V to -10V for the negative peak detector. This control also sets the range of the two 10 segment LED display drivers when the RANGE switch is set to PEAK mode.
Total current draw for TLN-904 depends on the number of LEDs, the type of LEDs, and how the LEDs are powered. For the example shown at the bottom of this page (using 25 high brightness LEDs powered from an onboard +5V regulator) the maximum current draw is 50 mA @+15V and 14 mA @-15V.


Ø 3.00 (1 Votes) Average Rating
submitted Mar 30th 2019, 12:34 by RandolphDMobius | last Change Sep 9th 2022, 13:11 by euphonic
Affiliate Disclosure
This page contains affiliate links from eBay, Reverb.com and other partners for which ModularGrid may be compensated.


Lower West Side Studio



These merchants probably sell this module. Huh?