ModularGrid uses so-called cookies to ensure it's so-called functionality. We also use dubious tracking scripts. Find out more in the Privacy Policy. We use cookies and wanna let you know.
Got it.
Bass Overdrive
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
This is a great Drive Pedal with a lot of versatility between clean and distorted. I bought it new about two years ago. I put Velcro on the bottom and used it for a couple of rehearsals with a short-lived project. Other than that, it’s in perfect condition. EBS BILLY SHEEHAN ULTIMATE SIGNATURE DRIVE. IF YOU EVER WANTED A SETUP WHERE YOU CAN BLEND A CLEAN BASS RIG WITH A DISTORTED, BUT CAN’T AFFORD TO HAVE TWO RIGS. THIS IS THE ULTIMATE SOLUTION FOR YOU!"This pedal is a distillate of several important principles in the signal chain for bass. Compression, distortion, tone-shaping and blending all together." - Billy SheehanMix the Clean with a Distorted signal pathSince the pedal splits the signal into two parallel paths – one clean and one with distortion – it becomes as if running the sound through two different bass rigs at the same time. The two Clean and Drive Level controls decides how you set the mix and melt the paths together. For a tighter, more defined sound you can engage the built-in compressor. Threshold settings for the compressor can be adjusted inside.Bring back more low-end and boost the gain when neededA Phase Inverter switch brings back more low-end to the drive channel in cases when phase cancellation appears. The Boost footswitch kicks up the drive gain a notch when needed.Extend the range of the Tone ControlThe new and major feature of the Ultimate version is the Hi or Lo Frequency Filter. This switch moves the whole frequency spectrum of the Tone filter up or down, to extend the capabilities of the pedal.The Hi setting adds a whole new palette of distortion sounds that was not possible to create with previous versions of the pedal.Mix in effects on the Clean and Drive channel separatelyThe individual Effect Loops for each channel can be used to color the channels individually with external effects. The Clean Loop jack can also be used as a clean input if you have a bass that features dual outputs. It sounds great if you run the lows through the Clean Loop jack while the mids/highs go through the main input, which leaves the lows untouched and only the higher frequencies treated by the drive.Inherited featuresThis version has inherited all the features from the Deluxe version (including the possibility to swap the drive chip without the need of soldering). But the palette of sounds you can create is expanded by the new Hi or Lo frequency filter to make it complete.EBS Billy Sheehan Ultimate Signature DriveNominal Input Level - 8 dBvInput Impedance 700 kohmsGain Range* Drive 20 - 50 dBBoost adjustable +3- 10 dBTone Filter Range 175 - 8000 Hz in two rangesQ 0.7-0.9Output Impedance Loops 2 kohmsInput Impedance Loops 47 kohmsMix Level Drive Channel +3 dB maxClean Channel +6 dB maxCompressor Ratio 5:1 (max)Threshold -25 +6 dBAttack Time (80%) < 7 msRelease Time (80%) 75 ms typMakeup gain 0, +3, +6 dBOutput Impedance < 50 ohmsDimensions W x H x D 3.3" x 4.5" x 1.9" (83 x 115 x 48 mm) including all hardwareWeight 420g (0.93 lb.)Type Analog Effect, Relay type SwitchingPower Requirements 9, 12 or 18 V DC, 60 mA max. Pedal shuts off below 6.0 V
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.