Oakley's Multimix mixer built by Lower West Side Studio

Mixers are one of the most useful utility modules available to the modular synthesizer performer and versatility makes them all the more useful. Enter the Multimix from Oakley Modular Systems. The Multimix is a 4 channel mixer with a twist.

The first three inputs have each an independant level control. Each level control can be set so that the gain of the input is anything from -1.1 to +1.1. This means that not only can inputs be added together, but can subtract as well. With each input knob set to its middle position, then none or very little of the input signal will reach the output.

A fourth input takes whatever signal is connected here and sums it with the final mixed output. This can be used to cascade several Multimixes together to form much larger mixers.

The Multimix features reversible attenuators on its inputs which are very useful for controlling audio and CVs. One excellent application uses a MultiMix with a VCA to create a very flexible ring modulator.

The module features a clever combination of four output sockets to achieve a variety of uses. Two mix outputs are available: One is MIX OUT and this is simply the four inputs added together – the first three inputs being added according to the levels set by the pots. The second main output is OUT3/MIX. This is exactly the same as MIX OUT until you start connecting jack plugs to either OUT1 and/or OUT2.

Inserting a jack into OUT1 and the IN1 signal will be removed from the OUT3/MIX socket. It will, however, still be present at the MIX OUT socket. The OUT1 socket gives you only that pot controlled version of the signal going into IN1. As before the pot will control the level and phase of the signal. You can thus use this pot to attenuate, or invert, CV or audio signals independantly of what is happening on the other three inputs. Inputs 2 and 3 also behave likewise. They can be treated as independant reversible attenuator channels or be treated as level controls on a mixer. It all depends on how those output sockets are used.

The module also features two output level LEDs. These monitor the signal level at the MIX OUT socket. The +5V one lights when the signal exceeds +/-5V. The peak one lights when the output signal is getting near clipping, ie. around +/-11V. Special circuitry is employed to ensure the LEDs do not cause power supply clicks when they turn on or off.

  • 35 mA +15V
  • 35 mA -15V
  • ? mA 5V
  • Ø 5.00 (1 Votes) Average Rating

This Module is currently available.

1 HP Mixer
submitted May 27th 2017, 01:11 by Flareless | last Change Oct 27th 2018, 09:56 by Flareless

Buy Online

These merchants probably sell this module. Huh?


SynthcubeAnalogue Haven