Tödliche Finger Model 601

Drop-in Boat power and distro

Turn your passive boat into an active one in less than a minute!

This module contains a power supply capable of 667mA on both +15 and -15 rails, and 1.5A on the +5V rail, as well as edge connectors for direct connection of up to 4 other modules. It also has an MTA header to connect to an external busboard, where available. No drilling or permanent connection to the case housing is required other than the usual panel-mounting screws-the +12V brick, and ground references from other boats, connect directly to the front panel.

Ready for production, distribution to be announced soon.


  • 50 mm deep

Available as an assembled Module and as a DIY project.

This Module is a prototype or in a concept phase.

1 HP Power
submitted May 22nd, 13:37 by gwaidan | last Change May 22nd, 13:39 by gwaidan
Specs are approved by the manufacturer