Saevitum V2

Abyss Devices

Manufacturer Page

Filter and Tube Distortion

New V2 updates:

Better distortion and vca response.
Toggle switch on both inputs to choose between modular level or high gain boost that’s high enough to use with very low signals like a guitar with passive pickups, or use it with other modules and completely distort the signal.
No more complex calibration at the back of the module. Just 1 trimmer to adjust the overall amount of RGB LED brightness and another trimmer to adjust the VCA offset which is calibrated by default to the best setting (you should not change this unless you notice something wrong).
New panel design and a few other very technical updates.

This module is gnarly and has a lot of gain distortion.
You can even use it without any input and it will do some weird noise using the resonance and feedback knobs. It will self oscillate with the resonance knob clockwise and feedback switch ON.
RGB LED is under the tube and reacts to the output signal.
You can choose which color using front panel trimmers or at the back trimmer for overall RGB effect amount.
RGB LED can be removed from the circuit and will allow a slightly cleaner more stable sound. (remove all black jumpers at the top right on the back of the module)

– Tube VCA Distortion

– Nasty unstable tube and filter circuit design

– 12AX7 JJ tube included

– Hi-Pass or Low Pass circuit using the switch

– CV Controls for cutoff, resonance, feedback and level

– Attenuator for each CV input with corresponding bipolar red/green LED

– Feedback circuit for gnarly unstable effects (even more gnarly if you use 2 different audio sources)

– Dry/Wet balance

– 2 Input mixing