The DIY Bend kit is a fun way to bring touch sensitivity into your modular instrument.

The DIY Bend kit is a fun way to bring touch sensitivity into your modular instrument. This simple build will have you touch controlling filter cutoff, pitch, lfo rate or any other CV input you can imagine within 30 minutes. The potentiometer attenuates the CV output, the hold control holds on the last touched position of the strip. Without the hold switch off, CV signal is only sent when touching the sensor.

http://www.eowave.com/modules/diy-bend/

  • 0 mA +12V
  • 0 mA -12V
  • 0 mA 5V
  • Ø 3.00 (1 Votes) Average Rating

This Module is currently available.

$66 submitted Jan 7th 2016, 00:09 by drsm79 | last Change Dec 9th 2017, 21:08 by Giraffatitan

Anonymous users have to activate their account to rate modules.


1 Users are observing this