4 HP
48 mm deep
Current Draw
20 mA +12V
20 mA -12V
? mA 5V
$86 Price in €

This Module is currently available.

S-180 8-Step Sequencer

S-180 8-step trigger sequencer

S-180 8-step trigger sequencer for Eurorack / Doepfer A100 – Ladik S-180.

Jacks: clock input, reset input, trig output
buttons: on/off steps, selectable seq length (2-8 steps), 3 modes: down, up/down, random
LEDs: dimmed light = sequence setting, full bright=actual step

to change seq mode (cycling in modes) – push and hold button no.1 for about 1s, LEDs will show selected mode
to on/off steps – push appropriate button shortly
to change seq length – push and hold appropriate button for about 1s

Long press of button 2 works as „manual reset“ or „sequence length=2″.
Function of button 2 (its long press) can be swapped by holding button 2 at power up. This selection is memorized.
Seq length is selectable from 2 (or 3 – depends of selected button 2 function) to 8 steps

Can be used as clock divider too (up to divide-by-eight):
to „divide-by-three“ for example set sequence length to three with first step active only. Clock pulses 1., 4., 7… appears on S-180 output…

S-181 Outs-8 – Breakout board (individual trigger outputs for every step, 4HP).
S-182 CV outputs (8x step CV + overall CV output range, 4HP)
P-110 Switchable trig/gate combiner (switchable „dual 3-to-1″ or „7-to1 combiner“ = logic „or“ = max signal selector, 4HP)
S-188 Voltage controlled clock shuffler (manual or external CV swing setting, 4HP)
S-190 Clock distributor (to chain up to 8 S-180, up to 64 steps, 16 clock distribution modes, 8HP)


Ø 4.73 (11 Votes) Average Rating
submitted Aug 11th 2014, 10:34 by ladik.eu | last Change Mar 5th 2020, 12:27 by jonjonjabadoo

26 Users are observing this