6 HP
32 mm deep

Module is a 1U tile.

Current Draw
9 mA +12V
13 mA -12V
0 mA 5V
$55 Price in €

Available as an assembled Module and as a DIY project.

This Module is currently available.

Three-state switch

In the simplest sense, this is a switching module. It is a little different though because it has 3 states rather than just on/off:

sgn(x) := {-1 if x < 0,
0 if x = 0,
1 if x > 0.}

In this case, the module uses approx 1V, rather than 0V, as the switching point, so that it can be controlled by gates. It is simple to bring it back to 0V for those who think it should be.
Also the '0' state is really a result of the diode voltage drops rather than any circuit design trickery.

The signal on the bottom input is fed to the switch of the Switch jack (oh yes) so the incoming signal can switch itself without any help.
The three states actually mean there is a flat spot at the switching point, so the circuit can be used for audio but at slow rates there is a click, so it is far better suited for CV processing.

This circuit originally was used as the nonlinear element in the Primal Hyperchaos and two of them in the Hyperchaos Deluxe. I quite like it on its own, so the Signum Hyperchaos brought the signum section to the panel where it could be used as a stand-alone module. This version drops the chaos and just has the Signum.
The switching is done by diodes rather than a dedicated IC.

The panels are available in white/gold and black/gold in both Pulp Logic and Intellijel formats. Please specify which colour and which format you want when ordering.

Also the PCBs are the same for both panel formats and use a standard Eurorack power connector. There is no provision for the Pulp Logic 3 pin power connector.

PCB and panel set = USD 10
Assembled = USD 55


Ø 5.00 (2 Votes) Average Rating
submitted Dec 14th 2019, 23:09 by anosou | last Change Mar 13th, 15:38 by senor-bling