4 HP
25 mm deep
Current Draw
30 mA +12V
0 mA -12V
0 mA 5V

Available as an assembled Module and as a DIY project.

This Module is currently available.

nQuencer turns the 16n faderbank into a step sequencer

nQuencer is a eurorack module that turns the 16n faderbank into a step sequencer.

connect a 3.5mm stereo cable to the i2c socket, patch in a clock and get a pitch and gate output.

when the nQuencer module receives a trigger at the Clock input it reads the state of the first 16n Faderbank fader and outputs a corresponding voltage at Output 1. At the next clock signal it will read the second fader and so on until it reaches the end and loops back to the start.

reset button and input to move back to the start

if a fader is at the very bottom no gate will be generated for that step in modes that output gates. The last fader that isn't at the bottom determines the length of the sequence.


Ø 5.00 (2 Votes) Average Rating
submitted Nov 29th 2022, 20:54 by tomwat | last Change Mar 22nd 2023, 09:14 by tomwat

1 Users are observing this

Affiliate Disclosure
This page contains affiliate links from eBay, Reverb.com and other partners for which ModularGrid may be compensated.