[o_o1

PRINTABLE Blank Panel │ "Circuit Chaos" │ 10 HP

3D Printing │ "Circuit Chaos" Blank Panel - 10 HP

Best to print with a 0.4mm nozzle, layer height: 0.2mm or smaller.

The “circuit chaos” is made of 0.5 and 1mm pipes so technically it should be possible to do 2 colour changes.

There are holes on the plate surface. They do not go through the model, but stop short at 0.2mm from the bottom face -→ depending on the filament you use, it is thin enough to let LED lights from inside your case to glow through.

3D-printed blank panels are often boring, so I try to make cool and easy to use ones.

https://www.printables.com/model/289181-eurorack-blank-panel-3u-2-to-20-hp-circuit-chaos