3340 Voltage-Controlled Oscillator (VCO) Classic Edition

VCO with CEM3340 Architecture

Featuring the legendary CEM3340 IC, the 3340 Voltage-Controlled Oscillator (VCO) module offers that classic, rich analog sound found in many famous synthesizers from the past, along with a wide range of sound shaping and modulation possibilities.

Features

• Original CEM3340 (Rev. G) architecture for a rich, analog sound.
• Four simultaneous, buffered 10Vpp (±5V) waveforms including DC-coupled ramp, triangle, sine and pulse outputs, with a controllable PW and PWM CV input (0V to 10V). Pulse output is derived from the CEM3340's triangle waveform using external circuitry.
• Coarse and fine frequency control knobs provide an adjustable frequency range of more than ten octaves (approximately 8Hz to 16KHz).
• 1V/octave input providing accurate tracking over more than ten octaves.
• Controllable CV inputs for linear and exponential FM.
• Comparator-based soft (with adjustable level) and positive/negative hard sync inputs offer versatility; allowing the VCO to be synced to many different types of sources, such as envelopes, sine waves, gate signals and so on.
• Vertical symmetry and roundness of sine wave can be independently adjusted.
• Classic-style knobs and panel design.
• Ergonomic design.
• Hand-built and tested in the UK.

https://www.wavefonix.com/product-page/3340-voltage-controlled-oscillator

• 60 mA +12V
• 50 mA -12V
• 0 mA 5V
• 40 mm deep

This Module is currently available.

Specs are approved by the manufacturer