LFO1 - VC LFO / S+H / Noise

Fully fledged LFO layed out in a more traditional monosynth format

A fully fledged LFO layed out in a more traditional monosynth format. Probably the only new LFO module that includes a Delay function. With the LFO1 there is no need to buy a separate Sample and Hold unit and Noise generator as they are all built in and can be used entirely independently from the LFO section.

Three modules in one:
The S+H and Noise units are independent to the LFO section so can be used entirely on their own (although their outputs are also available on the LFO waveform selection switch for convenience).

The Delay function:
When the delay function is activated via a voltage input at the DEL TRIG socket, the Delay LFO signal (out of the DEL socket) will start off with zero amplitude (no LFO signal), then gradually rise in modulation depth to maximum value, at a rate determined by the DELAY time pot.

http://analoguesolutions.com

  • ? mA +12V
  • ? mA -12V
  • ? mA 5V
  • Ø 5.00 (1 Votes) Average Rating

This Module is discontinued.

submitted Aug 1st 2013, 14:40 by mypetrobot | last Change Thursday May 28, 19:01 by motorhead412