Korg Delta/Poly-61 Filter Adaptation

The Delta VCF 8HP is back! Now draped in a space-age white screen aluminum panel, the Delta VCF 8HP a faithful clone of the Korg Delta synthesizer filter in Eurorack. The lowpass circuit was also found in the Poly-61. And uses the same OTA chips and dual transistor as the original Delta. It is all analog, no DSP, so it will warm up any signal run through it.

This Delta VCF 8HP version is the same circuit as my previous versions, and skiff/boat-friendly.

Two filter slopes: original 4-pole, and 2-pole.
Two filter modes: lowpass or bandpass.
Illuminated Frequency and Resonance Bourns Slider pots.
Mix together two different input oscillators at the input jacks w/ a MIX pot.
Setting the MIX fully CCW or CW can overdrive the filter.
Modulate the filter cutoff with two different input control voltages w/ signal attenuation pots.
Trim pots for adjusting frequency and resonance range. Some of you out there may want to give a little boost to the resonance trimpot on the PCB. Doing so will make this thing scream and howl a little harder.

Available exclusively in my Reverb Store http://reverb.com/shop/gstormelectro

  • 23 mA +12V
  • 20 mA -12V
  • 0 mA 5V
  • 22 mm deep

This Module is currently available.

$140 Price in € submitted Jan 23rd 2019, 21:44 by G-StormElectro | last Change Saturday May 23, 20:56 by motorhead412

1 Users are observing this