This Module is discontinued.
Eurorack BNC outputs. Can be used for oscilloscope connection or for direct access to CV &.Gate bus board signals (in/out).
Gate jack & BNC (can be connected to power bus board.Gate signal by internal jumper)
CV jack & BNC (can be connected to power bus board CV signal by internal jumper)
+5V, +12V and -12V power supply BNC outputs for noise/ripple/overload monitoring by scope
CV and Gate signals connection to bus board mode can be selected by internal jumpers:
– jumper set in top position = normalled connection to bus. If front panel jack is plugged-in it will disconnect BNC and jack from bus (jack and BNC are wired together)
– jumper set in bottom position = hardwired jack and BNC to bus board (jack can be used to direct CV/gate in/out to/from bus board in this mode)
– no jumper installed = jack and BNC connected together but isolated from bus board
