Available as an assembled Module and as a DIY project.
This Module is discontinued.
Quad Dual Active Slide Pot module
The SP-4DP has four 60mm throw high quality dual slide pots with both sets of taps each wired to a set of 1/8" jacks. Opposing end taps on each half of the dual slid pot are normalized to a range-selectable DC control voltage: 0V to +5V or +10V (approximate).
Each of the four slide pots in the SP-4DP control two sides which are electronically separate from each other, but mechanically linked sharing the same knob. Each slider can do any two of the following functions at the same time, to two different signal paths:
1. Pan-pot - alternately sends one signal (audio or CV) to two different destinations.
2. Segue - fades between two sources (audio or CV), sending the “mix” to one destination.
3. Attenuation - controls the output level of one signal (audio or CV)
4. DC control voltage - generates DC control voltages and outputs them.
The module can pass both AC and DC signals with output levels proportional to the position of the slider. The Jacks and slide pot are mounted to a 26 HP reversible panel. The panel graphics are so that the panel can be rotated to choose if the jacks are to the left or to the right of the slide pots for left or right handed operation, or for setting two unit side-by-side with 8 sliders together in a group.
The SP-4DP is 26HP in width and comes in two versions:
Fully assembled and tested at a MSRP of $200,
and as a DIY Kit version with all parts for a MSRP of $110.
17 Users are observing this
