Trig Xpander

RYO

Trigger/Gate expansion for the RYO VC Sequencer

Introducing the first official channel expander module for the VC Sequencer, the Trig Xpander.

This will give your VC Sequencer 8 individual outputs for each step outputting either a trigger or a gate, selectable with a jumper on the pcb, and a 9th output that gives you a trigger for each step progression. Also on board is a trimmer for setting the trigger length to your liking.

The outputs are diode isolated, this allows for passive mixing of the outputs using a passive multiple/stackcable/IV cable, or a switched multiple/OR combiner such as the Doepfer A-182 or Low-Gain Short Bus.

The kit comes supplied with two PCBs (one with a v-cut that you break into two), front panel (PCB material), component kit, power and expansion cables and mounting screws.

Solder and tools not supplied.

Will also be available as PCB and/or front panel only option and assembled module.

Basic specifications
Width: 4hp
Depth: ca 45mm
Power: +12mA / -0mA

  • 12 mA +12V
  • 0 mA -12V
  • ? mA 5V
  • 45 mm deep
  • Ø 5.00 (2 Votes) Average Rating

Available as an assembled Module and as a DIY project.

No info about availability.

submitted Jun 19th 2014, 04:12 by mindsnared | last Change Oct 22nd 2014, 19:36 by mindsnared

3 Users are observing this

Buy Online

These merchants probably sell this module. Huh?

USA

ControlSynthcubePerfect Circuit AudioModular Addict